Below you will find an in depth video installation guide for the AquaYouth 2.0 shower filter. Be sure to watch the entire video and feel free to pause it and playback parts of it as you install your unit.
Tools & supplies that you will need:
Thread seal tape (included)
Step 1: Detach your current shower head.
Remove the existing shower head from the shower arm by turning it counter-clockwise OR if you have a hand shower, remove the shower mount from the shower ar
Step 2: Clean & Dry The Shower Arm
Clean any excess material from the shower arm threads and dry any moisture with a towel.
Step 3: Wrap shower arm with thread seal tape (2 to 3 times around, clockwise)
Step 4: Attach the thinner end of the connector to the shower arm
Attach the connector to the shower filter.
Note: Pay attention to the "in" and "out" arrow indicators on the shower filter. The "in" side gets attached to the shower arm. The "out" side will be attached to the shower head.
Note 2: The connector contains two metal screws that can move independently, one end is thicker than the other. Connect the thicker end of the connector to the shower filter's "in" side
Step 5: Attach the thinner end of the connector to the shower arm
Step 6: Reattach the shower head to the shower filter
Step 7: Flush for 2 minutes to remove fine dust.
Run the water for 2 minutes to flush fine dust. Then you're ready to shower.
Congratulations, the installation is complete. If you haven't already, make sure to register your product.
After purchasing, don't forget to register your product to get access to your product warranty benefits. To register your product, please visit: www.AquaYouth.com/Register